Solution Description
dimensions | pcs/box | box size(cm) | kg/box | content | substance | material | |||||||
inch | mm | strip | bolt&nut | gasket | strip | bolt&nut | gasket | strip | bolt&nut | gasket | |||
1.5″ | DN40 | one hundred | forty two*32*25 | 12 | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
two” | DN50 | a hundred | forty two*32*25 | 12 | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
two.5″ | DN70 | a hundred | fifty*37*25 | sixteen.five | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
3″ | DN75 | 100 | fifty seven*forty two*27 | 17 | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
four” | DN100 | 50 | 58*39*27 | thirteen | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
5″ | DN125 | fifty | sixty seven*47*31 | 15.5 | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
six” | DN150 | 50 | 54*38*sixty | twenty | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
eight” | DN200 | twenty | sixty three*fifty one*33 | eleven | SS304 | SS304 | EPDM | SS316 | SS316 | EPDM | SS316 | SS304 | EPDM |
ten” | DN250 | NO | NO | NO | |||||||||
12″ | DN300 | NO | NO | NO |
Packaging:
1. Clean the shaft, the internal and outer holes of the bushing, and the inner gap of the hub. Eliminate any oil, paint or dirt, location the bushing on the hub, and match the half holes to make entire holes (each and every full gap will only be threaded on 1 aspect). Lightly oil the threads and details of set screws or the threads and heads of cap screws. Loosely location the screws in the threaded holes on the hub facet. Make sure the bushing is free of charge on the hub. Snap the assembly on to the shaft and place it in the wanted situation. Tighten the screws alternately and evenly until finally all are tight 5. Hammer the huge finish of the bushing with a hammer and block or socket to stay away from harm. The screw can now be turned a bit to the specified torque environment. Repeat this alternating hammering and screw retightening until finally the specified torque is reached. Fill all holes with grease to get rid of filth.